spd686danielwalker

Below is my final footwear presentation

[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/06/Daniel-Walker_Footwear-Final-Project.pdf” download=”all” viewer=”google” ]

Below is my research for my final project

[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/05/Luka_final-1.pdf” download=”all” viewer=”google” ]

Below is my inspiration for my final project

[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/05/Design-INSPIRATION-1.pdf” download=”all” viewer=”google” ]

Below is my final traction research and parametric design.

[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/05/Daniel-Walker_traction-Research-1.pdf” download=”all” viewer=”google” ]

Below is my upper research final

[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/05/Daniel-Walker_upper-research-final.pdf” download=”all” viewer=”google” ]

Below is my final upper project.

[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/05/Upper-Final_Daniel-Walker.pdf” download=”all” viewer=”google” ]

 

 

 

Below is my Process for taping my last.

 

I first began by adding the thin strip of masking tape to split the last into lateral and medial sides then added the tape for the feather edge.

 

Once that was complete I began to tape up both lateral and medial sides.

 

Then I removed the tape from the last and place in on paper to be cut out and measured.

Once the measured lateral and medial sides were on paper I created to additional sections and cut out the final patters.

 

Below is my presentation for my Footwear Rulebreaker

[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/04/Daniel-Walker-_Rulebreaker.pdf” download=”all” viewer=”google” ]

Below is my Basic Upper an d Rule Breaker presentation[embeddoc url=”https://blogs.uoregon.edu/spd686danielwalker/files/2020/04/Daniel-Walker-_Upper-basic-upper.pdf” download=”all” viewer=”google” ]